Service · Ventura and Santa Barbara Counties
Framing
in Ventura and Santa Barbara, CA
Cedar Sun Construction self-performs structural and non-structural framing across Ventura and Santa Barbara counties for new construction, additions, and remodels.
About our framing work
What Cedar Sun does on a framing project.
Framing is the backbone of every project we do. We frame from engineered plans, work to the structural engineer's calcs, and follow current California Building Code for shear walls, hold-downs, and lateral bracing. Our framing scope covers ground-up new construction, second-story additions, room additions and bump-outs, garage conversions to ADUs, load-bearing wall removals during remodels, and rough framing for decks and pergolas. We handle all the rough hardware (Simpson straps, hold-downs, hangers), set window and door bucks to manufacturer specs, and coordinate with the framing inspector at every required stage. Because we self-perform this scope, we can keep the schedule tight and the structural details clean.
Licensed, bonded & insured · CSLB #1137507
Scope
What's included in our framing scope.
Floor framing and subfloor
Wall framing (load-bearing and partition)
Roof framing (stick or truss)
Shear walls, hold-downs, and lateral bracing
Window and door bucks
Beam and header sizing per engineering
Simpson hardware installation
Framing inspection coordination
Where we work
Framing across both counties.
We provide framing services in every incorporated city across Ventura and Santa Barbara counties. Click your city for local details.
Cedar Sun has handled framing projects from Moorpark to Ventura to Moorpark.
Related
Other services we commonly pair with framing.
New Construction
Ground-up residential and commercial builds, foundation to finish.
View →ADUs (Accessory Dwelling Units)
Detached, attached, and garage-conversion ADUs, fully permitted.
View →Concrete
Foundations, flatwork, and structural concrete done right.
View →Home Remodels
Single-room updates to whole-home transformations.
View →Kitchen Renovations
Layout changes, cabinetry, countertops, and tile.
View →See our full services index for everything we do.
FAQ
Frequently asked questions about framing.
Do you frame from any architect's plans?
Yes. We frame from any set of stamped engineered plans. If you don't have engineering yet, we can recommend a structural engineer we work with regularly.
Can you remove a load-bearing wall?
Yes, with the proper structural engineering and permit. We size the beam, install temporary shoring during demo, set the new beam, and tie everything back together with Simpson hardware to engineering specs.
How long does framing a single-story addition take?
A 400 to 800 square foot single-story addition typically takes 2 to 3 weeks to frame, weather depending. Two-story additions add another 2 weeks for the upper floor and roof.
Do you frame ADUs?
Yes. ADUs use the same framing skills as any new construction; the structural details are just at a smaller scale. We frame both detached ADUs and attached additions.
Get Started Today
Ready to start your framing project?
Free estimates, no pressure. We'll walk through your project and give you an honest quote.